jobmate JMPRT550.1, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

11
3) Adjust the depth of the guide stop and tighten the locking
screws by turning them clockwise. (See Fig. G3)
8. INSTALL THE DUST EXTRACTION ADAPTOR
1) Insert the dust extraction adaptor into the back hole of the
base plate. (See Fig. H)
2) Insert vacuum cleaner hose into the connector.
NOTE: If the size of your hose’ nozzle does not match the
connector, use a piece of garden hose as an adaptor.
9. INSTALL THE SOFT SHAFT
1) Remove the bit if there is any.
2) Remove the chuck if it is not the Ø6.35mm one. Insert the
Ø6.35mm chuck into the spindle.
3) Insert the rear section of the soft shaft into the chuck. (See
Fig. I1)
4) After the rear section of the soft shaft is correctly
positioned inside the chuck, press the spindle lock button,
turn the chuck nut clockwise by hand. Make it as tight as you
can. (See Fig. I2)
Fig.G1
Fig.G2
Fig.G3
Fig.H
Fig.I3
Fig.I2
Fig.I1
Fig.J2
Fig.J1