jobmate JMPRT550.1, Инструкция по безопасности и эксплуатации

Страница: 10 / 16

10
3) Position the internal mounting disc, mounting hole (a) and
external mounting disc in a straight line as shown in below
figure. Press the three parts together. (See Fig. F3)
4) Tighten the external mounting disc by turning it clockwise
by hand.
NOTE:
• Make sure the protruding section of the external mounting
disc passed through the mounting hole and is fastened firmly
in place.
• Only tighten the external mounting disc by hand. Do not
over-tightened.
5) Loosen the pivot locking screw by turning it anti-clockwise.
Slide the screw to adjust the radius of the circle you are going
to cut. (See Fig. F4)
6) Insert the appropriate cutting bit into the chuck and tighten
it. Refer to ATTACH CUTTING BITS section.
NOTE: Measure the distance from the pivot to the outside of
the bit to check if the radius is adjusted correctly.
7) Adjust the depth gauge. Refer to ADJUST THE DEPTH
GAUGE section.
7. INSTALL THE GUIDE STOP
1) Loosen the 2 guide stop locking screws by turning them
anti-clockwise. (See Fig.G1)
2) Insert the adjustable guide stop into the base plate. (See
Fig. G2)
a
Fig.D1
Fig.D2
Fig.D3
Fig.E1
Fig.F2
Fig.F1
Fig.E2
Fig.F4
Fig.F3
Fig.G1
Fig.G2
Fig.G3
Fig.H
Fig.I3
Fig.I2
Fig.I1
Fig.J2
Fig.J1