jobmate JMCMS18G, Инструкция по безопасности и эксплуатации

Страница: 11 / 16

11
Fig.A
Fig.B
Fig.C
Fig.D
Fig.G
Fig.F
Fig.E
Fig.H
workbench to the floor before operating.
WARNING : Always make sure your compound
mitre saw is securely mounted to a
workbench or an approved work-stand. Failure to do
so could result in an accident, resulting in possible
serious personal injury.
When the saw is boxed, in storage, or being
transported, make sure that the saw head is locked
in the down position. To release the head to make it
ready for operation apply downward pressure and
pull out the lock pin, then turn 90
o
left or right to lock
it in place. The head will be raised gently to upper
position.
5. CHARGE YOUR BATTERY PACK (SEE FIG. D)
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Place the battery pack into the charger
3) When charging is completed, unplug the charger
and remove the battery pack.
NOTE: If the battery pack is locked in the charger,
press the battery pack release button
and remove it.
WARNING:
When battery charge runs out after
continuously use or exposure to direct sunlight or
heat, allow time for the tool to cool down before re-
charging to achieve the full charge.
OPERATION
1. SWITCH TRIGGER (SEE FIG. E)
When the blade has reached maximum speed,
unlock the lower rotating blade safety guard by
operating the switch locker using your forefinger. It
will then be feasible to push the saw head down by
the handle.
To turn on the saw, press the switch trigger
continuously. Release switch to turn off.
2. TO CROSSCUT WITH YOUR MITRE SAW (SEE
FIG F)
1. Remove the battery pack.
WARNING: To prevent personal injury, always
remove the battery pack from the tool before
assembling parts, making adjustments or changing
blades.
2. Pull out the lock pin and lift the saw arm to its full
height.
3. Loosen (unscrew) the mitre table lock knob
approximately one-half turn.