jobmate JMCMS18G, Инструкция по безопасности и эксплуатации

Страница: 10 / 16

10
Fig.A
Fig.B
Fig.C
Fig.D
Fig.G
Fig.F
Fig.E
Fig.H
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The electro-tool is intended as a stationary machine
for making straight lengthways and crossways
cuts in wood. Horizontal mitre angles of 0~45
o
L&R
as well as vertical bevel angles of 0° to +45° are
possible.
ASSEMBLY
1. MITRE TABLE LOCK KNOB (See Fig. A)
1. Place the threaded stud on the end of the mitre
table lock knob into the threaded hole in the control
arm.
2. Turn clockwise to tighten.
2. TO INSTALL DUST BAG (SEE FIG B)
This mitre saw comes with a dust bag to help you
keep the work area clean. The dust bag is ideal for
smaller jobs. Attaching the Dust Bag: Hold the dust
bag on both sides of the metal ring, place it on the
dust collection port, and then loosen the mental
ring. The dust bag is well installed by not falling off
when being pulled back gently.
3. WORK CLAMP (SEE FIG. C)
1) The work clamp can be fitted on either side of
the saw and is fully adjustable to suit the size of
the workpiece.
2) Do not operate the saw without clamping the
workpiece.
3) Make sure that the work clamp securing
screws are tightened.
4. MOUNTING HOLES
Your compound mitre saw should be permanently
mounted to a firm, stable-supporting surface, such
as a workbench. Four bolt holes have been provided
in the saw base for this purpose. Each of these four
mounting holes should be securely bolted using
10mm machine bolts, lock washers and hex nuts
(not included). Bolts should be long enough to fit
through the saw base, lock washers, hex nuts and
the thickness of the workbench.
Tighten all four bolts securely. Carefully check
the workbench after mounting the saw to make
sure that no movement can occur during use. If
any tipping, sliding or walking is noted, secure the