CDC160 DVD Case Wrapper
TP 000 103 - 10 -
5. With the screws loose, the guides can now be moved in or out up to 0.5mm. If the
guides are at their outmost position, move both guides fully to the centre. If the guides
are at their innermost point, move both guides back as far as they will go.
6. Tighten the screws on both guides
7. Replace both side covers, fit and tighten the 3 screws on each side.
8. Replace power cable.
Note:
The efficiency of operation of the CDC160 will obviously be controlled to some degree by
the ability and experience of the operator. However it is recommended that the CDC160
be operated on a suitably high surface allowing the operator to judge with some accuracy
the positioning of the pre-cut sheets of polypropylene in the unit.
3.3 Operating the CDC160
Wrapping the DVD Case on the CDC160 is a two-stage operation. The first stage involves sealing
two ends of a pre-cut sheet of polypropylene, wrapped around the DVD case, together. The final
stage folds and seals the edges of the sheet around the case automatically.
Lift up the hinged lid of the folding tray in front of the control panel and place the polypropylene
sheet centrally in the tray (figure 2) Ensure that one end of the sheet is pushed against the two
tabs at the front edge of the tray. (figure 3)
Figure 2
Figure 3
Place a DVD case in the tray on top of the polypropylene sheet. The case should be positioned so
that the spine of the case is nearest to you and that the case is placed against the front guide
(figure 4). The bottom of the polypropylene sheet will fold up against the spine of the case.