JMP FOX 4000 H, Руководство по эксплуатации

Страница: 48 / 62

46
12.15. Change of installation location
Preconditions corresponding to the installation guidelines must be established for a change of installation loca-
tion. Realise the location change according to the following procedure.
-
Raise the lift to approx. 500 mm.
-
Deactivate the main switch.
-
Disconnect the mains power.
-
Loosen and remove all covers.
-
Drain the oil tank.
-
Dismount the support arms. Pull out the pin and remove the support arm.
-
Detach the synchronisation cables at the bottom of the lift carriage in each case and feed the cable back to
the other column
-
Detach the electrical cable to the safety catch on the opposite side.
-
Detach the hydraulic lines between the cylinders. Seal the hydraulic connections with blind plugs if necesary.
-
Detach the crossbar between the two columns.
-
Release the dowel anchoring of the base plates.
-
Transport the lift to the new installation location.
-
Set up the lift in the same manner as for installation and dowel anchoring prior to initial commissioning.
⚠
New dowels must be used. The old dowels are no longer suitable for use!

A competent person must conduct a safety inspection prior to recommissioning (Use the
“Regular safety inspection” form).