JLG LIFTLUX 210-25, Руководство по эксплуатации и безопасности

Страница: 49 / 84

SECTION 4 - MACHINE OPERATION
3121303 – JLG Lift – 4-3
High Drive Speed Cutout
When the platform is raised by 3.5 m (11.5 ft) on the 210-25
and 3.7 m (12.1 ft) on the 245-25, the high drive speed will be
cut back to the low drive speed. Once the platform is com-
pletely lowered the high drive speed is possible.
Maximum Height Cutout
If the platform has reached it's maximum height, the lifting
function will be cut off by the max. height limit switch.
Maximum Drive Height Cutout
The maximum allowable drive height is 21 m (68.9 ft).
Oscillating Axle Limit Switch
When the platform is raised above 3.5 m (11.5 ft) on the 210-
25 and 3.7 m (12.1 ft) on the 245-25, and the axle inclination
is >1°, the drive function is cutout by a limit switch. When
the platform is below 3.5 m (11.5 ft) on the 210-25 and 3.7 m
(12.1 ft) on the 245-25, the inclination of the axle is ignored
and driving is possible.
AS THE PROPER FUNCTIONING OF THE LIMIT SWITCHES IS VERY
IMPORTANT FOR A SAFE USE OF THE MACHINE, THEIR FUNCTIONING
HAS TO BE CHECKED DAILY BEFORE THE START OF THE OPERATION!
• To make the check of the limit switches easy and conve-
nient, test lights (LED's) for each limit switch are located
on the platform control panel.
NOTE: On all functions, other than the overload, the LED will illu-
minate when the function is working properly.
The LED for the overload switch remains off until the plat-
form becomes overloaded.
Platform Extend/Drive/Lift Select
• Also located at the platform control box is the platform
extend/drive/lift select switch, which switches between the
platform extend, drive and lift-lower mode. This means
that platform extend, drive and lift/lower will be controlled
by the same controller (joystick) depending on the posi-
tion of the platform extend/drive/lift/lower select switch.
The steering (left/right) will be controlled by a separate
switch, which will be non active when the machine is in lift/
lower mode.