JLG LIFTLUX 210-25, Руководство по эксплуатации и безопасности

Страница: 30 / 84

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
2-8 – JLG Lift – 3121303
General
Begin the “Walk-Around Inspection” at Item 1, as noted on
the diagram. Continue to the right (counterclockwise
viewed from top) checking each item in sequence for the
conditions listed in the “Walk-Around Inspection Check-
list”.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE.
CHECKING THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDI-
TIONS WHICH COULD CAUSE EXTENSIVE MACHINE DAMAGE.
NOTE: On each item, make sure there are no loose or missing
parts, that they are securely fastened, and that no visi-
ble damage exists in addition to any other criteria men-
tioned.
1. Steer Linkage - See Note.
2. Steer Cylinder - See Note
3. Outrigger - (right front) - See Note
4. Wheel and Tire Assembly - Properly secured, no miss-
ing lug nuts. Refer to Section 6. Inspect wheels for
damage and corrosion.
5. Tie Rod and Spindle - (right front) - See Note
6. Lift Cylinder - See Note
7. Drive Hub, Right Rear - See Note
8. Outrigger - (right rear) - See Note
9. Outrigger - (left rear) - See Note
10. Fuel Tank - See Note
11. Drive Hub, Left Rear - See Note
12. Motor and Hydraulic Pump Assembly - Check engine
oil level. See Note
Figure 2-2. Walk - Around Inspection Points (Sheet 1)