SECTION 3 - CHASSIS, PLATFORM, & SCISSOR ARMS
31215079
3-31
8. Press front shaft bearing (15) onto shaft (16). Press
bearing onto shaft with lettering facing out. Lubri-
cate bearing rollers. Install snap-ring (17) onto shaft.
9. While holding the swashplate in place, turn the hous-
ing on its side. Install the install shaft/bearing assem-
bly into housing from the flange end. Install the
snap-ring (18).
10. Verify swashplate and bearings are properly seated.
Install the cylinder kit (19) onto the shaft. Install with
the slippers facing the swashplate. Rock the shaft to
align the block splines and slide the cylinder kit into
place. Orient the motor with the shaft pointing
downward and verify the cylinder kit, swashplate,
journal bearings, and servo piston are all secure and
properly installed.
11. Lubricate and install the servo spring (20), and mini-
mum angle stop (21) into the housing bore.
12. Press the rear shaft bearing (22) into the endcap.
Install the bearing with letters facing out. Press until
16
15
17
18
15. Front Shaft Bearing
16. Shaft
17. Snap Ring
18. Snap Ring
Figure 3-20. Shaft and Front Bearing
19
19. Cylinder Kit
Figure 3-21. Cylinder Kit Installation
20
21
20. Servo Spring
21. Minimum Angle Stop
Figure 3-22. Servo Spring and Minimum
Angle Stop
Go
to
Discount-Equipment.com
to
order
your
parts
