SECTION 3 - BASE COMPONENTS
3121228
–
JLG
Lift
–
3-23
Motor/Brush Cover - Remove/Install
Motor/Brush Cover - Removal/Installation
1.
Motor/Brush Cover (a)
2.
Cover Screws (b)
3.
Washers
4.
Power Leads to Lead Clips (Soldered)
5.
Power Lead Clip Attach Screws
REMOVE THE MOTOR COVER CAREFULLY, THE (SHORT) POWER LEADS INSIDE THE COVER FROM THE (+/—) POSTS ARE SOL-
DERED TO ATTACH CLIPS WHICH ARE FASTENED TO THE BRUSH CARRIER ASSEMBLY WITH SCREWS (ITEM-5). RAISE THE
COVER STRAIGHT UP - REMOVE THE SCREWS - THEN HINGE THE COVER UP (SEE CENTER ILLUSTRATION) AND PRY THE CLIPS
OFF OF THE BRUSH CARRIER ASSEMBLY TO COMPLETELY REMOVE THE MOTOR COVER.
NOTE:
(a) Once cover screws are removed, you may need to tap lightly around the edge of the top cover to separate it from the motor
housing. Read the note above before attempting to remove the cover.
(b) These steel screws are threaded into the aluminum valve body, do not overtighten.
2
3
1
4
5
