Jireh Rotix, Руководство пользователя

Страница: 27 / 59

PAGE 22 of 53
4.13.3. Clamp Setup
If the tube becomes disconnected
from the cable management dovetail
mount, follow these instructions to
re-attach the tube and dovetail mount.
1.
Loosen the clamp screw using the
supplied 3 mm hex driver.
2.
Slide the clamp around the
tube first and then slide the
tube around the outside of the
cable management dovetail mount
(Fig. 84)
. Align the zipper opening
and the cable management
dovetail mount opening.
3.
Slide the clamp over the tube and
cable management dovetail mount
pinching the tube in between
(Fig. 85)
.
4.
Tighten the clamp screw
(Fig. 86)
.
4.14. Reduced Width Scanning Kit
The encoded probe holding link houses
the main encoder and provides a
mounting base for probe holders.
To mount/adjust the frame bar, loosen
the bar adjustment knobs, insert bar,
slide to desired placement, then tighten
bar adjustment knobs.
Fig. 84
- Slide tube around mount
Fig. 85
- Slide clamp onto mount
Fig. 86
- Tighten clamp screw
Fig. 87
- Reduced width scanning kit