JH Industries Copperloy EDGE-OF-DOCK SEL Series, Инструкция по установке и эксплуатации

Страница: 14 / 42

14
JH INDUSTIRES INC.
1/4”
PLATE CLAMP
CENTERED ON
DOCKLEVELER
LIP RAMP
MOUNTING
PLATE
ANCHOR
HOLES
WARNING
!
WARNING
!
GENERAL INSTALLATION,
CONTINUED
9. Continuously weld dockleveler mounting plate to
curb channel, transition plate, angle plate or
steel approach ramp in accordance with AWS
Standards.
NOTICE!
Use care when welding. Do not allow weld or weld
spatter on the hinge tubes. Weld on the hinge tubes
may interfere with normal operation of the
dockleveler.
10. Plug weld remaining anchor holes in mounting
plate (if curb channel is not used, install
remaining 5/8” DIA. anchors).
11. Position bumper blocks and weld in place.
(See Figure 11).
12. Anchor bumpers with 5/8” DIA. anchors in holes
provided.
All anchor bolts must be installed in accord-
ance with the manufacturer’s instructions. Im-
proper installation may result in serious person-
al injury or death.
Do not install anchor bolts in cracks or
expansion joints in concrete. Installation in
cracks or expansion joints may cause the
anchors to come loose and pull out. Use of
improperly installed anchor bolts may result in
death or serious injury.
NOTICE!
All anchor bolt lengths must suit local codes and
conditions. Type and depth of concrete will
determine type and length of anchor bolts required.
13. Clean away all debris and paint all welded joints.
14. Raise the dockleveler and SECURE WITH THE
MAINTENANCE STRUT. See
(Figure 24 & 25).
15. Adjust two extension springs to assist in lifting
dockleveler from rest position. Check the
amount of bolt exposed beyond the spring face.
If the amount is the same the springs are
adjusted evenly. Adjust as required.
Do not over - adjust the extension springs.
Over - adjusting extension springs may cause the
dockleveler to bounce or float during use. Use of
an over
- adjusted dockleveler could result in
death or serious injury.
16. Once installed, on the front cover write in Model
#, Serial # and Date Installed. By doing this you
are agreeing to reading and following all safety
practices, manuals and instructions provided.
FIGURE 12
1” 1”
STANDARD
BUMPER
BLOCK
DOCKLEVELER (LIP
SHOWN UP FOR CLARITY)
FIGURE 11
OPTIONAL
BUMPER
BLOCK
14”
16”