Jets Munt Merlin M122NG, Инструкция по эксплуатации

Страница: 10 / 24

The screen will now change to:
Move the trim to low (or switch the “engine cut” switch
to On) and throttle stick back to zero and again press the
right hand button (+).
The display will now change to:
Leaving the throttle stick in the minimum position, raise
the throttle trim to the full up position or switch “Engine
Cut” switch to off, and again press the “+” button to
store the Idle position into the ecu.
If you have done all steps correctly the blue LED in the
ecu will light up flashing 2 times in the ECU when the
“Idle” command is received, meaning that trim and
throttle stick are set to idle positions on the transmitter.
Lower your throttle trim and the LED will change to a
single flash sequence indicating correct reading of the
transmitter engine shut off signal by the ecu.
10