Page 14
Section V ESTOP Screen
ESTOP
If the 9700W is in ESTOP at any time it will display in the
upper right corner of the screen. In addition the back light for
the display will flash so it can be easily seen.
Section VI Mechanical Installation
The 9700W control is mounted in a steel enclosure with a hinged front panel to facilitate servicing. The
front panel consists of a polycarbonate overlay with tactile switches and integrated touch pads.
Three Amphenol connectors are located on the right side of the enclosure. When planning the location
of the 9700W control, sufficient access for the connections should be provided at the right hand side of
the unit, we recommend allowing a space not less than 5” (125 mm).
The front panel is hinged for servicing purposes. The hinge is located at the left hand side of the
enclosure so it is important that you do not locate the 9700W too close to an obstruction on the left side
which would block the full opening of the door.
Plates are provided on the rear of the enclosure with four mounting holes, two at the top and two at the
bottom. The location and size of these holes is shown on the figure below. Use ¼” (6 mm) diameter
screws to secure the control to the mounting face.
We recommend that the control be mounted so that front panel is vertical or sloped back at an angle of
no more than 30° from the vertical. The vertical or slightly sloping front panel position will prove to be
best for the operator.
Because the control includes a digital display, the best location will be where the display is close to eye
height from the floor. The vertical front panel orientation ensures that the LCD display is clearly visible
- avoid a location where very bright light falls on the display, this causes a reflection from the transparent
overlay and make it difficult to clearly read the display.
RUN
ESTOP
OFF
12.1
DRY RUN
WIRE IPM
ADJUST
UNLOCKED
