Page 8
Please note that not all the screens in this manual appear on your 9700W. Your system or control
might not have the function. During programming if you disable a function it will not appear in run
screens.
WELCOME SCREEN
This screen appears automatically when the unit is switched on
and remains on the screen for approximately 3 seconds.
The next screen will appear automatically.
1.
RUN SCREENS
The operator must be in either of these two screens in order to begin a weld. If the right or left
buttons are pressed in the run screens, it will cause the wire to feed. A single press will give jog
speed. A double press will give rapid speed. When in the program portion of the menu, a left arrow
will save all the program parameters to the main menu.
WIRE SPEED
The wire screen sets the travel speed of the torch during the weld.
Wire feed speed is shown in IPM (inches per minute) or CPM
(centimeters per minute).
The number of decimal places is set in Configuration / Set DP.
The unit will limit the programmed speed to be between the high
and low speeds set up in the Calibration.
UNLOCKED OR LOCKED
The unlocked setting allows the user to change the speed during
the weld by adjusting the knob. Locked does not allow the user to
change the speed during the weld.
RUN
NORMAL
20.0
UNLOCKED
RUN
WIRE IPM
ADJUST
RUN
20.00
UNLOCKED
0.0
WIRE IPM
ADJUST
WIRE START DLY
