Page 20
C.
Interconnections
The 9700T control can be connected to other devices to provide more complete control of the
welding process. Standard length cables, complete with the appropriate Amphenol connectors are
available from Jetline. Special length cables can be made to order.
Refer to Figure 7 which shows a complete system interconnection scheme.
Note: The Miller TIG welding power supplies are available with a special 28-pin connectors, this
permits easy communication between the 9700T and the power supply. Power supplies from other
manufacturers can be used. Various remote interfaces for different power sources are available-
consult the Jetline factory for best fit regarding your application and power source model.
In this case the carriage drive motor is connected to, and controlled by the 9700T control which also
is connected to a Miller power supply.
Required Connections and Cables
showing old and new versions:
S1:
9627/9700T to welding power supply.
Cable: 9600S1-DX10-15 (For Miller)
Change to 9700S1-MLR28-15
S2:
Unused
S3:
9627/9700T to carriage drive motor
Cable: Included with carriage
Wire Feeder Addition
In addition to being interconnected with the welding power supply, the 9700T control can also be
interconnected with a Jetline wire feeder. All Jetline wire feeders use a 9700W series control giving
them complete compatibility with the 9700T.
When the 9700T carriage control is connected to the 9700W wire feeder control, the 9700T acts as
the primary control and the 9700W acts as the secondary unit. This means that the complete weld
sequence can be initiated by pressing the start button on the 9700T control. The weld and travel
sequence will be automatically started and, at the same time, a signal will be sent to the 9700W wire
feeder control to initiate the wire feed start sequence.
When the stop signal is given, either by pressing the stop button on the 9700T control or by this
control receiving a limit switch or encoder end of travel signal, the stop sequence set in the 9700W
wire feeder control will also be automatically initiated.
Required Connections and Cables showing old and new versions
:
9627 9700T
