JETI model Central Box, Руководство пользователя

Страница: 11 / 42

EN
reasons, always switch the system off via magnetic switch before
disconnecting the power batteries.
When turning “
ON ”, connect the batteries first and then turn the
system on via magnetic switch. Keep the same rule when switching
off. First switch the system “
OFF ” via magnetic switch and then
disconnect the batteries.
3 Connection
The Central Box is connected to the power supply, receiver, servos,
controller/controllers and eventually sensors. Please follow the
subsequent general guidelines about proper connection of the
Central Box and these other components.
Central Box 100 , Central Box 2 10 and 220 do not contain circuitry
to stabilize or regulate voltage to the servos.
The level of the input voltage is equal to the level of (output) supply
voltage level to the servos. Be sure to match the proper type of servos
with your selected power supply. Eg. when using 2 Li-xx cells without a
regulator, it is necessary to use servos labeled “High Voltage”.
3.1 Power supply of Central Box 210/220
The Central Box 210/220 can be powered from batteries which are
directly connected, via a BEC or a regulator. When selecting power
sources for the Central Box 220, be sure to follow the minimum
power requirements. Together, both power supply methods must
be able to supply a 15A continuous and 90A peak current. If the
power supply is not strong enough, the overload protection feature
of the Central Box 220 may not function correctly. The power
batteries are connected to the Central Box 210/220 using MPX
connectors. The Central Box 210/220 allows up to two batteries to
be connected. During use, the power is actually supplied from the
battery with the higher voltage. If the voltage is the same, the
power can be used from both batteries at the same time. When the
10 EN