21
EHB-8VS | EHB-8VSM
Fault
Probable Cause
Suggested Remedy
Bad cuts (rough)
1.
Blade speed too high for
feed pressure.
2.
Blade is too coarse.
1.
Reduce blade speed and
feed pressure.
2.
Replace with finer blade.
Blade is twisting
1.
Blade is binding in the cut.
2.
Blade tension too high
1.
Decrease feed pressure.
2.
Decrease tension on Blade
Unusual wear on side/back of blade
1.
Blade guides worn
2.
Blade guide bearings
not adjusted.
3.
Blade guide bearing bracket
is loose.
1.
Replace blade guides.
2.
Adjust blade guide bearings.
3.
Tighten blade guide
bearing bracket.
