Jet CL-1640ZX, Руководство по эксплуатации, Страница: 15 / 56

15
Gap Section
The gap section is sometimes removed on
lathes to allow room for working with a face
plate.
Refer to Figure 16.
1. Use the provided gap bridge pin driver to
loosen and remove the two taper pins (A,
Figure 16). Place the hex cap screw throug h
the driver and position over the taper hole.
Tighten the screw into the taper hole and
continue tightening until the pin comes
loose. Remove pin.
2. Remove four hex socket cap screws (B),
and two hex cap bolts (C).
3. Gap section can now be removed.
To re-install the gap section:
4. Clean the bottom and the ends of the gap
section thoroughly.
5. Set gap section in place and loosely install
the two hex cap bolts (C) and the four hex
socket cap screws (B).
6. Carefully align the gap with the bedways.
7. Push the taper pins (A) down through the
gap and into the lathe bed.
8. Tighten all screws.
Belt Replacement and Adjustment
1. Disconnect machine from power source.
2. Open upper and lower side covers to
expose the motor and v-belts.
3. Loosen upper hex nut (A, Figure 17). Place
scrap piece of wood under motor to act as
lever. Lift motor up and block temporarily.
4. Remove belts. Install new belts onto pulleys.
5. Lift up on motor and remove temporary
blocking.
6. Tension belts by loosening lower nut (B,
Figure 17) and tightening upper nut (A) until
light finger pressure causes approximately
3/4” deflection on each belt.
7. Install covers and connect lathe to power.
Figure 16
Figure 17