Jet CL-1640ZX, Руководство по эксплуатации

Страница: 10 / 56

10
2. Carefully remove the chuck from the spindle
and place on an adequate work surface.
3. Inspect the camlock studs. Make sure they
have not become cracked or broken during
transit. Clean all parts thoroughly with
solvent. Also clean the spindle and
camlocks.
4. Cover all chuck jaws and scroll inside the
chuck with #2 lithium tube grease. Cover the
spindle, camlocks, and chuck body with a
light film of 20W machine oil.
5. Lift the chuck up to the spindle nose and
press onto the spindle. Tighten in place by
turning the camlocks 1/4 turn clockwise. The
index mark on the camlock should be
between the two indicator arrows when
tight, as shown in Figure 4.
6. If the index mark is not between the two
arrows, remove the chuck and adjust the
camlock studs by either turning out one full
turn (if cams will not engage) or turning in
one full turn (if cams turn beyond indicator
marks.)
7. Install chuck and tighten in place.
Electrical Connections
Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded while in
use to help protect the operator from
electrical shock and possible fatal injury.
The main motor is rated at 10 HP, 3 Phase,
220V only. Confirm that power available at the
lathe’s location is the same rating as the lathe.
When opening the door of the electrical box, first
remove the screws. Then push the button, pull
out on the handle and rotate it counterclockwise
to release the door catch.
Bring the power cable up through the bottom of
the electrical box (Figure 5), and connect the
lead wires to the post and the grounding wire to
the plate on the left. (Consult the diagrams in
the M-320930-1
Parts Lists and Electrical
Diagrams manual.) Close the door of the
electrical box, and turn on the power by rotating
the Master Switch (Figure 6) clockwise.
NOTE: A safety device is installed whic h
prevents the electrical box door from being
opened at the same time as the Master Switch
is ON. You must close the electrical box door in
order to power on the lathe, or turn off the lathe
in order to access the electrical box.
Figure 4
Figure 5
Figure 6