Jet 718200K, Инструкция по эксплуатации и каталог запасных частей

Страница: 10 / 32

10
Installing Cutterhead Guard
The cutterhead guard has a spring tension
mechanism which must be properly
tensioned when installing the cutterhead
guard on the machine.
To install the cutterhead guard:
1. Insert a small hex wrench, or similar
object, into the pin on the guard tension
mechanism (Figure 8-1).
2. Twist the hex wrench and pin
clockwise, as shown in Figure 8-2, and
hold them there.
3. Lower the shaft of the guard into the
hole on the jointer’s rabbeting ledge.
See Figure 8-3. The guard should be
lowered into the hole far enough that
the groove in the guard’s shaft will
mate with the shaft of the set screw
(Figure 8-3).
4. After the guard has been inserted into
the hole, let go of the guard with your
left hand - the guard will swing toward
the fence.
5. Completely tighten the set screw
(Figure 8-3), while continuing to hold
the hex wrench and pin with your right
hand.
6. When the guard is secured, remove the
hex wrench from the pin. Slightly
loosen the set screw (Figure 8-3) until
the pin snaps back against the
rabbeting ledge.
7. Re-tighten the set screw (Figure 8-3).
Installing Access Door
Install access door by placing bottom of
panel into access in stand and fastening by
turning latch (Fig. 9).
If the access door latch needs
adjustment:
1. Remove the access door from the
stand.
2. Loosen the hex lock nut (A, Fig. 9).
Rotate the latch a quarter turn
clockwise to tighten and
counterclockwise to loosen.
3. Tighten the lock nut (A, Fig. 9).
4. Re-install the access door.
Figure 8-1
Figure 8-2
Figure 8-3