Jet Hangar A-7D/E Corsair II, Руководство по сборке

Страница: 37 / 66

JHI-A7-06-0001
Have questions? Call us at 562-467-0260 or email larrywjhi@jethangar.com 37
A.1 Decal Application Instructions
IMPORTANT! These are not your ordinary water transfer type decals.
There is no carrier film once applied to the model as is present on most
other water transfer decals. Please read and follow the instructions
carefully. It is a simple process, but all steps must be taken.
1. Carefully cut out the desired decal to be applied from the decal sheet. Cut
around the pink colored carrier film leaving an approximate ¼” offset from the
edge.
2. Put the transfer decal into water for 10-20 seconds; in some cases soaking up
to 30 seconds may be required for the decal to slide off easily.
3. Remove the decal and place it onto the model in the desired location. It is
best to slide the decal from the paper onto the model without physically lifting
the decal off of the paper.
4. When in the desired location, squeeze out any excess water and air bubbles.
5. Apply additional decals as desired using the same process described above.
6. Once complete, set the model aside for 3+ hours to allow the decals to dry.
7. After the 3 hours has passed, carefully peel away the clear/pink carrier film. It
is best to pull the carrier film back behind itself as it is removed from the
surface. It is recommended to allow some additional time for the decals to set
once the carrier film has been removed.
8. Finally, it is recommended to spray a clear coat over the decals to protect
them from fuel, UV light, etc.