Jesco EASYPOOL SMART 02, Руководство по эксплуатации

Страница: 37 / 44

EASYPOOL SMART 0 Operating Manual | 37
Troubleshooting
9.2 Fault resolution
Type of fault Possible cause Corrective measures
Insufficient water flow.
Can be identified through
insufficient movement
of ball valves in chlorine
measuring cell or "insuf-
ficient sample water"
display Needle valve set incorrectly Re-adjust the needle valve. (see start-up)
Shut-off valve in sample water line is not fully open. Check opening level of all valves
Sample water filter blocked. Clean filter or replace filter insert
Chorine measuring cell inlet nozzle blocked. Clean chlorine measuring cell and fit a sample water filter.
Sample water contact moved or faulty. Re-adjust or replace the contact.
Insufficient water pressure. Restrict the valve in the pool circuit or fit a sample water pump.
Disinfection control-
ler display fluctuating
although the
hand measurement gives
stable readings. Fluctuating pH value in water causes significant change in efficiency
of disinfectant. (The hand measurement is not affected) Stabilise the pH reading through appropriate controller adjustment.
Potential carry-over through electrical devices in the pool circuit Compensate potential: insert metal parts in front of and behind the
water sample station in the sample water line and connect them
together.
pH and REDOX meas-
urements cannot be
calibrated Probe cables swapped Fit the cables correctly
Probes are used up Fit new probes
Significant wear to
chlorine measuring cell
electrodes Water flow rate too high Reduce water flow until the measuring cell ball valves just reach the
highest point.
Copper electrode heavily worn in salt water. Use silver electrode
Particles in sample water (e.g. sand) Fit sample water filter.
Device revision
This operating manual applies to the following devices:
Device type: Revision Software version
EASYPOOL SMART 0 > 05/009 -
TOPAX DX SMART > 01/008 > 1.11.11
It contains all the technical information required for installation, start-up and maintenance. Should you have any questions or require
further information regarding this operating manual, please contact the manufacturer or their official national representative.