Jesco EASYPOOL SMART 02, Руководство по эксплуатации

Страница: 32 / 44

3 | EASYPOOL SMART 0 Operating Manual
Installation and Commissioning
Temperature sensor
The temperature sensor is fitted and connected at the factory. It
does not require calibration.
Conductivity measuring cell
The conductivity measuring cell is factory-fitted at the top of the
water sampling station. To protect it during transport the connec-
tor is loosened and must be refitted during start-up.
Calibration is described in detail in the controller operating man-
ual.
5.6 Starting automatic mode
Presetting of the control parameters is appropriate for many
swimming pool applications not in accordance with DIN 19643.
For this reason the control system can be switched on initially
without changing the control parameters. If this does not pro-
duce a good control result, the parameters can subsequently be
changed (see controller description).
Provide the chemical supply for the pH adjustment and disinfec-
tion in turn by inserting the suction lines in turn into the vessel.
Note how the dosing starts each time via the peristaltic pump.
Do not start dosing the disinfectant (or start the flow-through
chlorine electrolysis) until the measured pH value has reached
its target value and dosing of the pH adjustment solution has
finished.
CAUTION!
The chemicals can be hazardous in concentrated
form. Handle them therefore with care. Always use
suitable protective clothing for hands, body and
mouth/nose when handling chemicals. Avoid using
exposed chemicals. Read the chemicals' safety data
sheets in detail and follow the instructions on the
packaging of the chemicals.
Observe the system in operation. If there are any faults to the
controller or the peristaltic pumps, or if there are major devia-
tions between the readings and the target values, consult the
troubleshooting section.
IMPORTANT!
Re-calibrate all sensors 24 hours after the initial in-
stallation.