9
CR2032
OPEN
PUSH
POWER SOURCE
This unit operates using the included AC adaptor with 12V 3000mA (center-positive
) output and is compatible with standard 120V~ 60Hz AC household power or with
10 “D” size (UM-1) batteries (Not included).
The remote control operates on one 3V type CR2032 lithium battery (Included).
A. AC POWER CONNECTION
1. Insert the the DC Plug of the AC Adaptor into the DC IN jack on the back of the unit.
Plug the AC Adaptor into a standard 120V~ 60Hz AC wall outlet.
2. Slide the main power switch on the back of the unit to the “ON” positon, the unit is
now in standby mode.
3. You can now press the button on unit or remote control to turn on the unit. The
display shows “HELLO”.
4. Press the button on unit or remote control to turn off the unit, then the display
shows “GOOD--BYE”. Slide the power switch on the back of the unit to “OFF” positon,
and pull the AC adaptor out of the wall outlet if you
want to switch off completely.
B. BATTERY OPERATION
Note
: For best performance and longer operating time, we recommend the use of alkaline-
type batteries.
1. Remove the Battery Door on the back of the unit.
2. Follow the marked polarities and install 10 “D” size (UM-1) batteries.
3. Replace the Battery Door.
IMPORTANT
- Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
:
Be sure that the batteries are installed correctly.
Wrong polarity may
damage the unit.
BATTERY CARE
- Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
- Only batteries of the same or equivalent type as recommend are to be used.
- If the unit is not to be used for an extended period of time, remove all batteries. Old or
leaking battery can cause damage to the unit and may void the warranty.
- Do not dispose batteries in fire. Batteries may leak or explode.
- Danger of explosion if battery is incorrectly replaced.
C. REMOTE CONTROL
The remote control operates on one CR2032 battery (included). To
activate the remote control, remove the insulation tab inserted in the
battery compartment.
When the operation of the remote control becomes intermittent or
unsatisfactory, replace the original battery with a new 3-volt lithium battery.
1. Slide out the battery holder from the remote control case.
2. Replace the 3V CR2032 battery. Be sure the battery is installed
correctly. The remote will not work if the battery is installed with the
wrong polarity.
CR2032
CR2032
