![background image](http://html1.mh-extra.com/html/jensen/jiss-700i/jiss-700i_user-manual_644396011.webp)
10
CAUTION:
Danger of explosion if the battery is replaced incorrectly. Replace only with
the same type battery.
3. Insert the battery holder back into the battery slot.
NOTE:
Only use a well-known brand of cell battery to ensure the longest life and best
performance.
LISTENING TO RADIO
1. Press the
button on unit or remote control to turn on the unit and use the
FUNCTION
button on the unit or remote control to select the TUNER mode.
2. To manually tune a radio station, press the
or
button on unit or remote control
to change the frequency by 0.05MHz interval. Use the manual tuning method to tune
to weaker stations that are bypassed during automatic tuning.
3. To automatically tune to the next radio station with strong signal, press and hold
or
button for 1 second until frequency readout on the display begins to scan and then
release the button. The tuner will stop scanning when it receives the next strong
station signal.
4. The STEREO indicator "
((ST))
" will show on the display when a stereo signal is
received.
5. Adjust the VOLUME control to obtain the desired sound level from the Built-in
Speakers.
HINTS FOR BEST RECEPTION:
To insure maximum FM tuner reception, the telescopic FM antenna should be fully
extended and rotated to obtain the best possible station reception.
NOTE:
Automatic tuning depends on the signal strength of the broadcsting station, so
weak stations may be skipped. You can manually tune to find the weak stations if a
station gets skipped. With strong signals, the tuner may stop before it reaches the actual
broadcast frequency, so you may need to manually tune for the best reception.
STEREO / MONO SELECT (REMOTE CONTROL ONLY)
When receiving a weak or noisy FM station, setting the sound to monoaural may improve
the reception. Press the
FM MONO/ST/STOP
button on remote control to switch
between MONO or STEREO reception.
STATION MEMORY
You can also save up to 20 FM stations of your choice and store them in memory.
1. Tune in a radio station you would like to save.
2. Tap the
PROG.
button on the unit or remote control and the
preset location number will flash on the display.
3. Press the
PRESET/FOLDER(UP or DN)
button on remote
control to change the preset location if needed.
4. Tap the
PROG.
button again to store the FM station in memory.
5. Repeat steps 1 to 4 to store more stations or change previously stored stations.
6. Recall the stored channels by pressing the
PRESET/FOLDER(UP or DN)
buttons on
remote control.