Jenn-Air KitchenAid KBSD708M S00 Series, Техническое руководство

Страница: 25 / 44

COMPONENT ACCESS (CONT.)
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
n
4-5
Removing the Condenser Fan Assembly
1. Complete the steps 1-3 from section Removing the Front
Decorative Cover.
2. Complete the steps 1-2 from section Removing the Front
Access panel.
3. Complete the steps 1-2 from section Removing the Unit Top
Cover.
4. Locate the condenser fan assembly in the back of the
compartment, to the right of the compressor.
5. Disconnect the wire harness located next to the fan assembly.
6. Remove four (4) 1/4" hex head screws to remove the
condenser fan assembly.
Accessing the Compressor and Inverter
1. Complete the steps 1-3 from section Removing the Front
Decorative Cover.
2. Complete the steps 1-2 from section Removing the Front
Access panel.
3. Complete the steps 1-2 from section Removing the Unit Top
Cover.
4. Locate the inverter in front of the compressor.
5.
Compressor wire connections and electrical cover are located
on the left of the compressor.
6. Four (4) 7/16" hex head bolts are used to mount the
compressor.
7. The three (3) 1/4" hex head screws used to mount the
inverter are located at the base of the inverter (Refer above
figure).
A. Compressor
B. Inverter