COMPONENT ACCESS (CONT.)
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
n
4-3
Removing the Unit Top Cover
1. Remove four (4) 1/4" screws from the right side and six (6)
1/4" screws from the left side.
2.
Lift the Unit Top Cover off.
Removing the Control Board
1. Complete the steps
from section Removing the Front
Decorative Cover.
2. Complete the steps
from section Removing the Front
Access panel.
3. Remove two (2) 1/4" hex head screws from the power switch
and humidity sensor mounting bracket, then remove the
bracket.
4. Disconnect all the wires.
5.
Push the release tabs on the left and top side of the board
and slide board out of the mounting brackets on the right
side.
Figure - Unit Top Cover Left Side
Figure - Unit Top Cover Right Side
A. ON/OFF Switch
B. Humidity Sensor
Содержание KitchenAid KBSD708M S00 Series
Страница 4: ...iv n JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators Notes...
Страница 42: ...Component Access 4 22 n JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators Notes...
Страница 44: ...JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators W11636548 Rev A...