GENERAL INFORMATION (CONT.)
JennAir® and KitchenAid® 36", 42", and 48" Built-In Side by Side Refrigerators
n
1-11
Power Outage
The power outage indicator lets you know if the power supply to
the refrigerator has been cut off and the freezer temperature has
risen to 18°F (– 8°C) or higher. When power has been restored,
the button repeatedly flashes and the red Power Outage icon
appears. When the indicator is on, all other control and
dispenser functions are disabled until you confirm that you are
aware of the power outage.
To enable other functions, press Measured Fill to reset the
display screen to its normal status.
Water and Ice Dispensers
Please read before using the water system. Follow the directions
specific to your model.
Style 1 (Dispenser Models)
IMPORTANT:
n
After connecting the refrigerator to a water source, replacing
the water filter, follow the steps below to make sure that the
water system is properly cleaned. This will flush air from the
filter and water dispensing system, and prepare the water
filter for use.
n
Connect to potable water supply only.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
NOTE:
If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the
horizontal position.
1. Open the freezer door and turn OFF the ice maker. The ON/
OFF switch is located on the top right side of the freezer
compartment. Move the switch to the OFF (right) setting as
shown.
2. Use a sturdy container to depress and hold the water
dispenser lever for 5 seconds, then release it for 5 seconds.
Repeat until water begins to flow. Once water begins to
flow, continue depressing and releasing the dispenser lever
(5 seconds on, 5 seconds off) until a total of 3 gallon (12 L)
has been dispensed. This will flush air from the filter and
water dispensing system and prepare the water filter for use.
Additional flushing may be required in some households.
NOTE:
As air is cleared from the system, water may spurt out of
the dispenser.
3. Open the freezer door and turn on the ice maker. Move the
switch to the ON (left) position.
NOTE:
n
Allow 24 hours to produce the first batch of ice.
n
Discard the first three batches of ice produced.
n
Allow 3 days to completely fill ice container.
Style 2 (Non-Dispenser Models)
IMPORTANT:
After connecting the refrigerator to a water source
or replacing the water filter, fill and discard two full containers of
ice to prepare the water filter for use, before using the ice.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
NOTE:
If your model has a base grille filter system, make sure the
base grille filter is properly installed and the cap is in the
horizontal position.
1.
Turn on the ice maker. Lower the wire shutoff arm as shown.
NOTE:
n
Allow 24 hours to produce the first batch of ice.
n
Allow 3 days to completely fill ice container.
n
Depending on your model, you may want to select the
maximum ice feature to increase the production of
ice.
IMPORTANT:
n
After connecting the refrigerator to a water source, replacing
the water filter, flush the water system. Use a sturdy
container to depress and hold the water dispenser lever for 5
seconds, then release it for 5 seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever (5 seconds on, 5
seconds off) until a total of 3 gal. (12 L) has been dispensed.
This will flush air from the filter and water dispensing system,
and prepare the water filter for use. Additional flushing may
be required in some households.
NOTE:
As air is cleared from the system, water may spurt out
of the dispenser.
n
Allow 24 hours for the refrigerator to cool down and chill
water.
n
Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
n
The dispensing system will not operate when the freezer door
is open.
n
Depending on your model, your water and ice dispensers
may have one or more of the following features: A dispenser
tray, a special light that turns on when you use the dispenser,
or a lock option to avoid unintentional dispensing.
Содержание KitchenAid KBSD708M S00 Series
Страница 4: ...iv n JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators Notes...
Страница 42: ...Component Access 4 22 n JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators Notes...
Страница 44: ...JennAir and KitchenAid 36 42 and 48 Built In Side by Side Refrigerators W11636548 Rev A...