Jenn-Air JEC0530ADB, Сервисная инструкция

Страница: 15 / 26

©2004 Maytag Services
16023537 15
Disassembly Procedures
!
WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to cooktop before servicing, unless
testing requires power.
Main Top Removal
1. Disconnect power to cooktop.
2 Remove cooktop from installation position and place
face down on protected surface.
3. Remove screws securing main top to burner box
bottom.
4. Remove screws securing control panel box and
conduit mounting plate to burner box assembly.
5. Remove main top.
6. Reverse procedure to reassemble, verifying that
cooktop frame is properly aligned.
NOTE: Make sure the pieces of insulation, located in the
front left and right rear corners, are put back in
place. Failure to do so could create excessive
cabinet temperatures.
Element Replacement
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing element clips to main top.
NOTE: Element clips are positioned at numbered
locations. If element clips are removed from
element, note the locations prior to removal.
3. Disconnect and label wiring to element.
4. Replace element and reverse procedure to reinstall.
Sensor Replacement
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing element clips to main top.
3. Lower element and remove screws securing sensor to
element.
4. Disconnect wiring to sensor.
5. Replace sensor and reverse procedure to reinstall.
Limiter Replacement (Dual Element Only)
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing element clips to main top.
3. Lower element and remove screws securing limiter to
element.
4. Disconnect and label wiring to limiter.
5. Replace limiter and reverse procedure to reinstall.
Limiter Replacement (Triple Element Only)
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing element clips to main top.
3. Lower element and remove screws securing limiter to
element.
4. Disconnect and label wiring to limiter.
5. Replace limiter and reverse procedure to reinstall.
Hi–Limit Switch Replacement
1. Remove main top, see "Main Top Removal"
procedure.
2. Remove screws securing hi-limit switch to the
mounting plate and remove hi-limit switch.
3. Disconnect and label wiring to hi-limit switch.
4. Replace hi-limit switch and reverse procedure to
reinstall.
Cooling Fan Replacement
1. Disconnect electricity to unit.
2. Remove knobs from valve stems.
NOTE: To remove knob(s), slide a rag under the knob
and pull upward.
3. Remove cooktop from installation position and place
face down on protected surface.
4. Remove screws securing bottom baffle to burner box
bottom.
5. Remove baffle to gain access to fan.
6. Remove screws securing cooling fan to burner box
bottom.
7. Disconnect and label wiring to cooling fan.
8. Replace cooling fan and reverse procedure to
reinstall.