13
Troubleshooting
ISSUE:
Weapon doesn‘t react at all after battery connection.
SOLUTION:
Check if the battery is properly connected and charged. Also check motor
contacts and motor functionality. Check if the safety fuse hasn’t been blown.
ISSUE:
Weapon doesn‘t make shots after trigger pull (start-up vibration was made).
SOLUTION:
Damaged or misplaced micro switch for trigger, check it‘s proper function.
ISSUE:
Selector is set to semi but act like on SAFE or AUTO (or any other combination).
SOLUTION:
Damaged or misplaced micro switch for selector plate, check its proper functi-
on through micro switch check page in the app and correct selector plate shape
according page 7 in this manual.
ISSUE:
Micro switch for sector gear is pressed after motor stop (Error 100).
SOLUTION:
Gun have too high rate of fire and piston make over spinning. Solve it by incre-
asing active brake or reducing pre-cocking (if used) or reducing rate of fire or use
battery with lower voltage or change gear ratio or use low speed high torgue motor.
ISSUE:
Selector plate has moved during shooting (Error 101).
SOLUTION:
You have changed by mistake fire selector during shooting or it was changed
by vibrations from shooting. Check microswitches through app, if they change sta-
te too close the selector position, modify selector plate shape to change it further.
ISSUE:
Trigger is pressed during battery connection (Error 102).
SOLUTION:
Release the trigger and try again. Check for right trigger microswitch function.
ISSUE:
The gun always shoots BURST with short-long beep after fire (Error 103).
SOLUTION:
Cycle micro switch doesn‘t detect sector gear motion. Use micro switch check
function to move cycle micro switch to the right position detecting edte at the gear.
ISSUE:
High temperature on the mosfet (Error 104).
SOLUTION:
Wait until temperature will be dropped down. If it repeats, mosfet is overloa-
ded by too high Amps. Change gearbox internals to drain less amperage.
Содержание Leviathan
Страница 1: ...INSTALLATION MANUAL FOR GEARBOX V2 ...
