Jeep Grand Cherokee SRT 2018, Руководство пользователя

Страница: 28 / 666

The system uses a key fob, keyless push button
ignition and a RF receiver to prevent unauthor-
ized vehicle operation. Therefore, only key fobs
that are programmed to the vehicle can be used
to start and operate the vehicle. The system will
not allow the engine to crank if an invalid key fob
is used to start and operate the vehicle. The
system will shut the engine off in two seconds if
an invalid key fob is used to start the engine.
After turning the ignition switch to the ON/RUN
position, the vehicle security light will turn on for
three seconds for a bulb check. If the light
remains on after the bulb check, it indicates that
there is a problem with the electronics. In addi-
tion, if the light begins to flash after the bulb
check, it indicates that someone used an invalid
key fob to start the engine. Either of these
conditions will result in the engine being shut off
after two seconds.
If the vehicle security light turns on during normal
vehicle operation (vehicle running for longer than
ten seconds), it indicates that there is a fault in the
electronics. Should this occur, have the vehicle
serviced as soon as possible by your authorized
dealer.
CAUTION!
The Sentry Key Immobilizer system is not
compatible with some aftermarket remote
starting systems. Use of these systems may
result in vehicle starting problems and loss of
security protection.
All of the key fobs provided with your new vehicle
have been programmed to the vehicle electronics.
Customer Key Programming
Programming key fobs may be performed at
your authorized dealer.
Replacement Keys
NOTE:
Only key fobs that are programmed to the
vehicle electronics can be used to start and
operate the vehicle. Once a key fob is pro-
grammed to a vehicle, it cannot be programmed
to any other vehicle.
CAUTION!
•
Always remove the key fobs from the ve-
hicle and lock all doors when leaving the
vehicle unattended.
•
For vehicles equipped with Keyless Enter-
N-Go — Ignition, always remember to
place the ignition in the OFF position.
NOTE:
Duplication of key fobs may be performed at an
authorized dealer. This procedure consists of
programming a blank key fob to the vehicle
electronics. A blank key fob is one that has
never been programmed.
When having the Sentry Key Immobilizer Sys-
tem serviced, bring all vehicle keys with you to
an authorized dealer.
Irregular Operation
The system uses a key fob, an Ignition Node
Module, Keyless Push Button Ignition and a RF
receiver to prevent unauthorized vehicle opera-
tion. Therefore, only key fobs that are pro-
grammed to the vehicle can be used to start and
operate the vehicle. The system will not allow
the engine to crank if an invalid key fob is used
to start and operate the vehicle. The system will
shut the engine off in two seconds if an invalid
key fob is used to start the engine.
NOTE:
A key fob that has not been programmed is also
considered an invalid key.
During normal operation, after placing the key-
less ignition in the ON/RUN mode, the Vehicle
Security Light will turn on for three seconds for a
bulb check. If the light remains on after the bulb
check, it indicates that there is a problem with
the electronics. In addition, if the light begins to
flash after the bulb check, it indicates that some-
one used an invalid key fob to try to start the
engine. Either of these conditions will result in
the engine being shut off after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than
10 seconds), it indicates that there is a fault in the
electronics. Should this occur, have the vehicle
serviced as soon as possible by an authorized
dealer.
25