Jeep Grand Cherokee SRT 2018, Руководство пользователя

Страница: 157 / 666

WARNING!
Leaving the Adaptive Cruise Control (ACC)
system on when not in use is dangerous. You
could accidentally set the system or cause it
to go faster than you want. You could lose
control and have a collision. Always leave the
system off when you are not using it.
To Set A Desired ACC Speed
When the vehicle reaches the speed desired,
push the SET (+) button or the SET (-) button
and release. The instrument cluster display will
display the set speed.
If the system is set when the vehicle speed is
below 19 mph (30 km/h), the set speed shall be
defaulted to 19 mph (30 km/h). If the system is
set when the vehicle speed is above 19 mph
(30 km/h), the set speed shall be the current
speed of the vehicle.
NOTE:
ACC cannot be set if there is a stationary vehicle
in front of your vehicle in close proximity.
Remove your foot from the accelerator pedal. If
you do not, the vehicle may continue to accel-
erate beyond the set speed. If this occurs:
•
The message “DRIVER OVERRIDE” will dis-
play in the instrument cluster display.
•
The system will not be controlling the dis-
tance between your vehicle and the vehicle
ahead. The vehicle speed will only be deter-
mined by the position of the accelerator
pedal.
To Cancel
The following conditions cancel the system:
•
The brake pedal is applied.
•
The CANC button is pushed.
•
An Anti-Lock Brake System (ABS) event
occurs.
•
The gear selector is removed from the DRIVE
position.
•
The Electronic Stability Control/Traction Con-
trol System (ESC/TCS) activates.
•
The vehicle parking brake is applied.
•
Driver seatbelt is unbuckled at low speeds.
•
Driver door is opened at low speeds.
•
The driver switches ESC to full-off mode.
•
The braking temperature exceeds normal
range (overheated).
•
A Trailer Sway Control (TSC) event occurs.
To Turn Off
The system will turn off and clear the set speed
in memory if:
•
The Adaptive Cruise Control (ACC) on/off
button is pushed.
•
The Normal (Fixed Speed) Cruise Control
on/off button is pushed.
•
The ignition is turned OFF.
•
You switch to Four-Wheel Drive Low.
To Resume
If there is a set speed in memory push the RES
(resume) button and then remove your foot from
the accelerator pedal. The instrument cluster
display will display the last set speed.
NOTE:
•
If your vehicle stays at standstill for longer
than two seconds, then the system will cancel
and the brake force will be ramped-out. The
driver will have to apply the brakes to keep
the vehicle at a standstill.
•
ACC cannot be resumed if there is a station-
ary vehicle in-front of your vehicle in close
proximity.
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming
a set speed that is too high or too low for
prevailing traffic and road conditions could
cause the vehicle to accelerate or decelerate
too sharply for safe operation. Failure to
follow these warnings can result in a collision
and death or serious personal injury.
154