Jeep Compass, Руководство пользователя

Страница: 29 / 322

27
Forward/rearward adjustment
Push switch (1) fig. 22 forwards or
backwards to move the seat in the
corresponding direction. Release the
switch when the desired position has
been reached.
Height adjustment
Use the front part of the switch (1)
fig. 22 to modify the height and/or the
angle of the seat cushion.
Reclining bucket seats
Push switch (2) fig. 22 forwards or
backwards to adjust the backrest in the
corresponding direction.
24)
Power lumbar adjustment
(where provided)
With the ignition device on RUN, use the
joystick (3) fig. 22 to operate the lumbar
area device to obtain maximum driving
comfort.
Driver memory seat
(where provided)
This feature allows the driver to store
up to two different profiles, for easy
recall through a dedicated button. Each
memory profile contains desired position
settings for the driver seat and a set of
desired radio station presets.
The memory control buttons are located
on the driver's side door panel fig. 23.
The buttons for storing profiles are 3: the
button (S) to activate the memory save
function and buttons (1) and (2) related
to the memory profiles. The memory
buttons allow the driver to recall either of
the two pre-programmed memory profiles
by pushing the appropriate number
button on the switch.
23
5520302D
Programming the Memory feature
To create a new memory profile, perform
the following:
NOTE Saving a new memory profile will
erase an existing profile from memory.
1. Bring the ignition device to RUN.
2. Adjust all memory profile settings to
desired preferences (i.e., seat and radio
station presets).
3. Press and release the (S) and memory
buttons, then press the button marked
with the number (1) within five seconds.
The EVIC, if equipped, will display which
memory position is being set.
If desired, a second memory profile can
be stored into memory as follows:
1. Cycle the vehicle’s ignition to the ON
position.
2. Adjust all memory profile settings to
desired preferences (i.e., seat and radio
station presets).
3. Press and release the (S) and memory
buttons, then press the button marked
with the number (2) within five seconds.
The EVIC, if equipped, will display which
memory position is being set.
NOTES:
Memory profiles can be set without the
car’s dual clutch automatic transmission
in the P (Park) position, but the vehicle
must be in the P (Park) position to recall
a memory profile.
To set a memory profile to your key
fob, refer to the “Linking the Remote
Keyless Entry key fob to Memory”
paragraph.
Linking the Remote Keyless Entry key fob to
Memory
Your remote keyless entry key fob can
be programmed to recall one of two pre-
programmed memory profiles with a
push of the button on the key fob.
NOTE Before programming your key fob
you must select the “Memory Liked To
FOB” function through the Uconnect™
system screen. Refer to the “Settings”
paragraph in the “Multimedia” section
for further information.
To program your key fob, perform the
following:
1. Cycle the vehicle’s ignition to the OFF
position.