Jeep Compass, Руководство пользователя

Страница: 205 / 322

203
Data” section) or the pressure
indicated on the specific label, stop the
compressor by pressing the ON-OFF
button again;
disconnect the cartridge (A) fig. 154
from the compressor, by pressing the
release button (H) and lifting the
cartridge upwards.
153
J0A0957
A
H
154
J0A0958
If the pressure gage (G) fig. 153
indicates a pressure lower than 1.8 bar
(26 psi) 15 minutes after starting the
compressor, switch off the compressor,
disconnect the sealing fluid tube D from
the tire valve and remove the cartridge
(A) from the compressor.
Move the car by approximately 10 meters
to allow the distribution of the sealant.
Stop the vehicle safely, operate the
electric handbrake and restore pressure
using the black inflation pipe (L)
fig. 155 to reach the required pressure.
If also in this case, the pressure is lower
than 1.8 bar / 26 psi 15 minutes after
turning on, do not resume driving but
contact a Jeep Dealership. After driving
for about 8 km / 5 miles fig. 156, move
the car to a safe and suitable area and
engage the electric handbrake. Take the
compressor and restore pressure using
the black inflation tube (L).
L
155
J0A0959
8 km / 5 mi
156
J0A0960
If the pressure shown is higher than
1.8 bar / 26 psi, restore the pressure
and drive safely to a Jeep Dealership
as soon as possible. If, however, the
pressure is lower than 1.8 bar / 26 psi,
do not resume driving but contact a Jeep
Dealership.
PROCEDURE FOR RESTORING
THE PRESSURE
Proceed as follows:
stop the car safely, as described
above, and operate the electric
handbrake;
extract the black inflation tube and
screw it firmly onto the tire valve. Then
follow the instructions below. Press
the air release button M to adjust any
excessive tire pressure (see "Repair
procedure" paragraph).
CARTRIDGE REPLACEMENT
Proceed as follows:
only use original cartridges, which can
be purchased from the Jeep Dealership;