Jeep Compass, Руководство по эксплуатации

Страница: 19 / 310

NOTE:
When having the Sentry Key® Immobilizer
System serviced, bring all vehicle keys with
you to an authorized dealer.
Customer Key Programming
See your authorized dealer if you require re-
placement or additional keys for your vehicle.
General Information
The Sentry Key® Immobilizer is a 433.92 MHz
system. It will be used in the following European
countries, which apply Directive 1999/5/EC:
Austria, Belgium, Czech Republic, Denmark,
Finland, France, Germany, Greece, Hungary,
Ireland, Italy, Luxembourg, Netherlands, Nor-
way, Poland, Portugal, Romania, Russian Fed-
eration, Slovenia, Spain, Sweden, Switzerland,
Yugoslavia, and United Kingdom.
•
This device may not cause harmful interfer-
ence.
•
This device must accept any interference
that may be received, including interference
that may cause undesired operation.
PREMIUM VEHICLE SECURITY
ALARM — IF EQUIPPED
The Premium Vehicle Security Alarm system
monitors the doors, hood latch, liftgate, and
ignition switch for unauthorized operation.
If something triggers the security alarm the
audible alert will sound for 29 seconds and flash
the lights for 60 seconds. If the triggering device
is not deactivated, the audible alert will sound
again after a five-second delay for another 29
seconds. If the trigger remains present, this
cycle will repeat for up to five minutes.
If the intrusion sensor is enabled, the security
alarm system will also monitor the vehicle for
movement. When this portion of the alarm is
set, movement inside the vehicle or movement
of the vehicle will trigger the Vehicle Security
Alarm.
To Arm The System
1. Remove the key from the ignition switch and
get out of the vehicle.
2. Lock the door using either the power door
lock switch, or the Remote Keyless Entry (RKE)
transmitter and close all doors.
3. The Vehicle Security Light in the instrument
cluster will flash rapidly for 16 seconds. This
shows that the security alarm is arming. After 16
seconds the locks will activate and the Vehicle
Security Light will continue to flash slowly. This
shows that the Vehicle Security Alarm system is
fully armed.
NOTE:
The intrusion sensor (motion detector) ac-
tively monitors your vehicle every time you
arm the security alarm. If you prefer, you can
turn off the intrusion sensor when arming
the security alarm.
To disable the intrusion sensor, activate the
LOCK request three times using the RKE trans-
mitter during the arming period (lamp flashing
quickly). The intrusion sensor will automatically
be enabled the next time the security alarm is
set.
15