CAUTION!
(Continued)
a can or balance beads if your vehicle is
equipped with a TPMS, as damage to the
sensors may result.
23. Odometer Display/Trip Odometer Dis-
play
This display indicates the total distance the
vehicle has been driven.
Vehicle Odometer Messages
When the appropriate conditions exist, the fol-
lowing odometer messages will display:
door
. . . . . . . . . . . . . . . . . .Door Ajar
gATE
. . . . . . . . . . . . . . . . . .Gate Ajar
gASCAP
. . . . . . . . . . . . .Fuel Cap Fault
CHAngE OIL
. . . . . . .Oil Change Required
HOTOIL
. . . . . . . .Engine Oil Temp Too Hot
NOTE:
If the vehicle is equipped with the optional
Electronic Vehicle Information Center (EVIC)
in the instrument cluster, all warnings in-
cluding “Door Ajar”, and “Gate Ajar” will
only be displayed in the EVIC display. For
additional information, refer to “Electronic
Vehicle Information Center — If Equipped”.
gASCAP
If the vehicle diagnostic system determines that
the fuel filler cap is loose, improperly installed,
or damaged, a “gASCAP” message will display
in the odometer display area. Tighten the fuel
filler cap properly and press the TRIP ODOM-
ETER button to turn off the message. If the
problem continues, the message will appear the
next time the vehicle is started.
A loose, improperly installed, or damaged fuel
filler cap may also turn on the Malfunction
Indicator Light (MIL).
HOTOIL
When this message is displayed there is a
engine over-temperature condition. When this
condition occurs, the “HOTOIL” message will be
displayed in the odometer along with a chime.
Refer to “Engine Oil Overheating” under in
“What To Do In Emergencies”.
CHAngE OIL Message
Your vehicle is equipped with an engine oil
change indicator system. The “CHAngE OIL”
message will flash in the instrument cluster
odometer for approximately 12 seconds after a
single chime has sounded to indicate the next
scheduled oil change interval. The engine oil
change indicator system is duty-cycle based,
which means the engine oil change interval may
fluctuate dependent upon your personal driving
style. Unless reset, this message will continue
to display each time you turn the ignition switch
to the ON/RUN position. To turn off the mes-
sage temporarily, press and release the Trip
Odometer button on the instrument cluster. To
reset the oil change indicator system (after
performing the scheduled maintenance), refer
to the following procedure:
Turn the ignition switch to the ON/RUN position
(do not start the engine).
125
Содержание Compass
