JDS Uniphase SmartClass, Руководство пользователя

Страница: 30 / 90

Chapter 3 Instrument Settings
Enabling PTM mode
16 SmartClass ADSL/Copper Tester User’s Guide
Enabling PTM mode
If your unit is equipped with the PTM option, this menu allows you to enable
pattern transfer mode (PTM mode).
To enable PTM mode
1 Select SYSTEM SETUP from the Main Menu.
2 Select PTM SETUP .
3 Select ENABLE .
Viewing the battery status
The battery menu reports the following:
– type of battery
– battery status
– voltage
To view the battery status
1 Select SYSTEM SETUP from the Main Menu.
2 Select BATTERY .
3 View the battery status.
4 Press the Cancel key to exit the menu.
Setting the language
The LANGUAGE menu allows you to change the language of the user inter-
face.
To set the language
1 Select LANGUAGE from the Main Menu.
2 Select the desired language.
The user interface changes to the specified language.
NOTE:
When PTM is enabled, no data tests can be done (IP Ping, Trace Route,
and so on). To run data tests, disable PTM mode.
NOTE:
You also use this menu to manually start charging the batteries, if necessary
(see the last bullet in
“General preparation” on page 4 ).