17
User manual
7- Cleaning
7.5 Cleaning the doser openings
7.6 Removing and cleaning the mixing tray
1. Press and hold
STOP (A)
and
ENTER (B)
buttons for 2-3
seconds to enter the cleaning mode (See Fig.1).
2. The display will show
FLUSHING
, press
UP
or
DOWN
until the display shows
CLEANING
, then press
ENTER
to
continue. Follow the instructions on the display:
REMOVE ALL PRODUCT PACKS
3. Open the dispenser door.
4. Remove the product packs (See Fig.2).
5. When all packs have been removed the display will
automatically continue and the display will show:
CLEAN COOLING BOX PRESS ENTER WHEN DONE
6. Clean the doser opening with a brush and the interior of the
cooling compartment with a clean, damp cloth (See Fig.3)
and dry with a clean cloth or paper towel before replacing.
Fig.4
Fig.5
+B
A
A+B:
2-3
sec
Fig.1
Fig.2
Fig.3
A
B
C
1. Press
ENTER
, the display will show:
REMOVE AND CLEAN MIXING TRAY SYSTEM
2. Follow the three steps below: (See Fig.4)
A. Open the fluid treatment panel. There will be one audible
beep.
B. Remove the outlet tube.
C. Pull the mixing tray straight out. There will be a another
audible beep.
i
Note:
To save dispensing time, it is recommended to use the
included service kit, which contains a clean mixing tray.
Then, the dirty parts can be cleaned and exchanged next
time the mixing tray is cleaned.
3. Place the mixing tray in a bin with locally approved
food-grade cleaning agent and hot water and soak for
approximately 15 minutes. (See Fig.5) Rinse with clean water
before replacing.
i
Note:
Comply with the safety instructions and cleaning
instructions on the cleaning agent packaging.
The mixing tray can also be washed in a dishwasher.