JCM GEN5 Series, Руководство по эксплуатации и обслуживанию

Страница: 38 / 70

P/N 960-100940R_Rev. A © 2016, JCM American Corporation
4 - 4
Section 4 GEN5™ Series Printer Disassembly/Reassembly
Bottom Presenter Mechanism

Disassembly
To remove the Bottom Presenter Mechanism, pro-
ceed as follows:
1. Remove four (4) screws on the bottom rails (Fig-
ure 4-11 a
1
thru a
4
).
2. Lift the Bottom Presenter upward slightly.
3. Remove the nut from the ground lug (Figure 4-11
b ) using a
1
⁄
4
” Nut Driver.
4. Remove two (2) screws securing the Bezel LED
Connector.
5. Remove the Bezel LED Harness from the hold-
ing clip.
6. Lift the Bottom Presenter (Figure 4-11 c ) out of
the Bottom Tray.
Taken Sensor Removal
To remove the Taken Sensor, proceed as follows:
1. Remove two (2) screws (Figure 4-12 a
1
and a
2
)
securing the Taken Sensor (Figure 4-12 b ).
2. Remove one (1) connector (Figure 4-12 c ).
3. Lift the Taken Sensor off the Bottom Presenter.
Lid Closed Sensor Removal
To remove the Lid Closed Sensor, proceed as fol-
lows:
1. Remove two (2) screws securing the Lid Sensor
(Figure 4-13 a
1
and a
2
).
2. Disconnect one (1) connector.
3. Remove the Lid Sensor (Figure 4-13
b ).
Presenter Motor and Rollers
To remove the Presenter Motor and Rollers, pro-
ceed as follows:
Presenter Motor
1. Remove two (2) screws securing the Presenter
Motor (Figure 4-14 a
1
and a
2
).
2. Remove the Presenter Motor (Figure 4-14 b )
from the Assembly.
Figure 4-11
Remove Bottom Presenter
a
1
a
2
c
a
3
a
4
b
Figure 4-12
Remove Taken Sensor
a
1
a
2
b
c
Figure 4-13
Remove Lid Sensor
a
1
a
2
b
Figure 4-14
Remove Presenter Motor
a
1
a
2
b