© 2016, JCM American Corporation
2 - 2
Section 2
Installation
Manual Baud Rate Setting
If it becomes necessary to manually configure
Baud Rate Settings on the GEN5 Printer Unit, per-
form the following steps:
1. Remove the rubber plug from the side of the
Printer (refer to Figure 1-4
j
).
2. Set DIP Switches SW1 through SW4 to select the
desired Baud Rate (Table 2-1).
3. Open the Printer lid.
4. Press and hold the Feed Button for one (1)
second.
5. Close the Printer lid.
6. Power cycle the Printer Unit.
7. Print a Configuration Ticket to verify that the
Baud Rate Setting has been changed.
Disabling the Paper Low Sensor
If it becomes necessary to disable the GEN5
Printer Unit’s Paper Low Sensor, perform the fol-
lowing steps:
1. Remove Paper from the Print Head.
2. Put the GEN5 Printer in a "Paper in Chute" con-
dition. Cover the Taken Sensor (Figure 2-11
e
)
with your finger or a Ticket.
3. Press and hold the Feed button (Figure 2-4
a
) for
3 seconds. If the GREEN Ready light flashes, the
Paper Low Sensor has just been turned ON. If the
RED Fault light flashes, the Paper Low Sensor
has just been turned OFF.
Содержание GEN5 Series
Страница 10: ...THIS PAGE INTENTIONALLY LEFT BLANK GEN5 Series Printer P N 960 100940R_Rev A 2016 JCM American Corporation viii...
Страница 62: ...P N 960 100940R_Rev A 2016 JCM American Corporation 8 2 GEN5 Series Printer THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 69: ......
Страница 70: ...GEN5 Series Printer P N 960 100940R_Rev A 2016 JCM American Corporation...
