![background image](http://html2.mh-extra.com/html/jcm/gen5-series/gen5-series_operation-and-maintenance-manual_3557210030.webp)
© 2016, JCM American Corporation
2 - 8
Section 2
Installation
5. Pull the Print Head Release Lever to release the
Print Head (Figure 2-7
a
).
6. Use non-flammable compressed air to remove
dust and dirt from the compartment, Print Head
(Figure 2-9
a
), Rollers, Paper Out Sensor and
Taken Sensor.
7. Press down on the Print Head Release Lever to
lower the Print Head, then gently wipe a cotton
swab along the length of (and inside) the Print
Head (Figure 2-9
a
). Then return the Print Head
Release Lever to its closed position.
8. To clean the Print Head Rollers (Figure 2-10
a
)
and Feed Rollers (Figure 2-10
b
), turn the Rollers
by hand while wiping them with a new Cleaning
Wipe or a clean Microfiber cloth (slightly damp-
ened with Isopropyl Alcohol).
Sensors Cleaning Procedure
The GEN5 Printer has five (5) Sensors that work
with the EGM firmware to provide reliable product
performance.
To clean the GEN5 Printer Sensors, follow this
procedure:
1. Press the Lid Release Lever to open the Printer
a
).
2. Clean the surfaces of the Sensors using Isopropyl
Alcohol and a clean cotton swab.
3. Close the Printer Lid.
4. Realign the Printer with the Sliding Base, then
reinstall it into the EGM.
Figure 2-9
Clean Print Head
a
Figure 2-10
Clean Print Head Rollers and
Feed Rollers
a
b
Table 2-9
GEN5 Printer Sensor Cleaning Methods
Symbol
Sensor Type
Cleaning Method
a
Printer Tray
(Drawer Open)
Wipe clean with an
alcohol swab.
b
Ticket Low
(Paper Low)
Wipe clean with an
alcohol swab.
c
Paper Out
(Index Mark)
Blow clean with
Compressed Air
d
Lid Open
Wipe clean with an
alcohol swab.
e
Taken Sensor
Wipe clean with an
alcohol swab.
NOTE: Refer to Figure 2-11 and Table
2-9 for Printer Sensor Locations and
Cleaning Methods.
NOTE: The Paper Out (Index Mark)
Sensor (Figure 2-11
c
) is located
within the Print Head approximately 1
inch from its right edge. This sensor
should be cleaned using non-
flammable Compressed Air.
NOTE: Make sure Tickets are properly
loaded in the Printer before resuming
normal operation.
Figure 2-11
Printer Sensor Locations (cut-away)
e
b
a
c
d
Содержание GEN5 Series
Страница 10: ...THIS PAGE INTENTIONALLY LEFT BLANK GEN5 Series Printer P N 960 100940R_Rev A 2016 JCM American Corporation viii...
Страница 62: ...P N 960 100940R_Rev A 2016 JCM American Corporation 8 2 GEN5 Series Printer THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 69: ......
Страница 70: ...GEN5 Series Printer P N 960 100940R_Rev A 2016 JCM American Corporation...