CAPTIVE SYSTEM
jcm
technologies
25
Before programming, place the options selectors at the desired position. Any subsequent change will require a receiver
reset and reprogramming.
Press the PROG button on receiver and hold it until the desired mode is selected. LED's for R1 & R2 will flash in
sequence to select the correct operation mode.
There are four programming modes, depending on the inputs you wish to use of the transmitter and the outputs
required to activate on the receiver.
The receiver allows programming 6 safety edges (3 for Relay 1 and 3 for Relay 2). A safety edge can only be
programmed to one receiver.
In case of CAP ACTIVE/CAP T, safety edge is IN1 and NO TOUCH function is IN2
