ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
5/33
PANTHER/JAGUAR
OPERATING INSTRUCTIONS
PANTHER
/
JAGUAR
units can be linked together as master/slave in a daisy chain and use the built-in
chase sequences automatically or by sound activation.
No need to set the dipswitches in master/slave mode.
When linking the PANTHER and the JAGUAR in stand-alone mode, the JAGUAR must be used as the
master unit.
2-light show
Dipswitch 10 “off” means the unit works normally.
Dipswitch 10 “on” means inversion.
In order to create a light show, you can set the dip switch 10 “on” on any unit that is linked to the master unit
to get inversed movement, even if you have only two units.
Dipswitch 10 is not used on the first unit of the Daisy chain, as it is the master unit that operates the light
show.
Connect the optional CA-8 controller for more control:
The CA-8 controller can only be used in standalone or master/slave mode. Connect the controller to the CA-
8 input of the first unit (master). Now you can control all the connected units:
Controlled by universal DMX-controller:
Connect all units together. (don’t forget to address all units
properly!)
Connect all units to the mains and turn on the DMX controller.
Since each unit has its own DMX-address, you can control them
individually. Remember that each unit uses 4 DMX-channels as
shown in the DMX chart below:
Stand by
Blackout the unit
Function
1. Hold on for gobo strobe effect
2. Press shortly for gobo change
1. Press shortly for gobo change
Mode
Fast mode: Sound activated
(LED off )
Slow mode: Not sound activated
(LED on)
ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
6/33
PANTHER/JAGUAR
MAINTENANCE
Make sure the area below the installation place is free from unwanted persons during servicing.
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
Clean with a soft cloth using normal glass cleaning products.
Always dry the parts carefully.
Clean the external optics at least once every 30 days.
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
AC 230V, 50Hz
Fuse:
20mm Glass 5A Fast Blow(20mm glass)
Sound Control:
Internal microphone
DMX connections:
3pin XLR male / female
Lamp:
ELC 250W/24V
Size:
470 x 314 x 245 mm
Weight:
10 kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
