ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
3/49
SUPER WINNER
Important:
Never look directly into the light source! Don’t use the effect in the presence of
persons suffering from epilepsy.
DESCRIPTION:
1. Optical lens with manual focus adjustment
2. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to
fix a mounting hook.
3. Mains input with IEC socket and integrated fuse holder, connect the supplied mains
cable here.
4. Lamp compartment, to be opened with this screw.
5. Internal microphone
6. ¼” jack used to connect the optional CA-8 controller.
7. DIP switches, used to set the DMX-starting address of the unit.
8. DMX input: 3pin male XLR-connector used to connect universal DMX-cables. This
input receives instructions from a DMX-controller or from another Winner light effect
when used in master/slave mode.
9. DMX output: 3pin female XLR-connector used to connect the Winner with the next unit
in the DMX chain or with another Winner when used in master/slave mode.
10. Scanning mirror
11. Button used to control the music sensitivity
ENGLISH
OPERATION
MANUAL
JB SYSTEMS®
4/49
SUPER WINNER
LAMP (RE)PLACEMENT
In case of replacement of the lamp or maintenance, do not open the
fixture within 10 minutes until the unit cools down after switching off.
Always unplug the unit before servicing! Always use the same type of
spare parts (bulbs, fuses, etc.) When replacing parts, please only
genuine spare parts.
•
Switch off the unit and unplug the mains cable.
•
Wait for about 10 minutes until the unit has been cooled down.
•
Use a screwdriver to unscrew the screw that closes lamp compartment of the fixture.
•
On the inside you will see the lamp. Tear the lamp gently out of the lamp holder.
•
Unscrew the 2 wires from the wire terminal
•
Install the 2 wires from the new lamp in the wire terminal and make sure to fasten the
terminals well.
•
Press the new lamp gently in the lamp holder.
Attention!
Check the label on the backside of the device or see the technical
specifications in this manual to know which lamp should be used. Never install lamps
with a higher wattage! Lamps with higher wattage generate temperatures the device was
not designed for. If the device uses a lamp transformer, it will burn due to current
overload.
•
Don’t touch the bulb inside the reflector of the lamp with bare hands! This drastically
shortens the lifespan of the lamp. If you touched the lamp, clean it with a cloth and a little
denatured alcohol. Wipe the lamp off before installing.
•
Be sure that the wires don’t touch the lamp.
•
Close the lamp compartment with the screw.
•
Done!
OVERHEAD RIGGING
•
Important:
The installation must be carried out by qualified service personal only.
Improper installation can result in serious injuries and/or damage to property.
Overhead rigging requires extensive experience! Working load limits should be
respected, certified installation materials should be used, the installed device
should be inspected regularly for safety.
