ENGLISH
USER MANUAL
JB Systems
®
4/13
Accu Color
ELECTRICAL INSTALLATION
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Note: In the explanations below we assume that you will operate the projectors with the internal battery
which is already fully charged. If you want to use them with a mains cable, simply connect all projectors to
the mains using the supplied power cable.
Electrical installation for 1 standalone unit:
•
Switch the projector on using the power switch (17). The unit starts working immediately in the last
selected stand-alone mode.
•
Refer to chapter [HOW TO SETUP] to learn how to switch between different working modes.
Electrical installation for two or more units in master/slave:
•
Make sure that all units are switched on.
•
Setup 1 unit as Master (see [SETUP MENU]) and wireless transmitter (see [SETUP FOR WIRELESS
OPERATION]). Setup the other units as Slave (see [SETUP MENU]) and wireless receiver (see [SETUP
FOR WIRELESS OPERATION])
•
Done
Remark: You can connect a JBS LEDCON-02 Mk2 remote controller to the master unit if you want to have
more control over the master/slave operation.
Electrical installation for two or more units in DMX-mode:
You can control the Accu Color by DMX in different ways, depending on your needs. You can go for a wired
solution (using cables), you can go for a completely wireless solution or you can go for a combination of
both…
