ENGLISH
USER MANUAL
JB Systems
®
3/13
Accu Color
•
Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important:
Never look directly into the light source! Don’t use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1.
Antenna for wireless connection
2.
Handle to easily carry the projector.
3.
Lens in front of RGBWA 10W LED
4.
Knob used to fasten the projector in a desired angle between 0° and 25°.
5.
Projector base.
6.
DMX Output connector XLR Female 3P.
7.
DMX Input connector XLR Male 3P.
8.
Mains output with ProCon connector : you can use a special XLR/Powercon cable to connect up to max.
16A (power).
9.
Mains input with ProCon connector : you can use a special XLR/Powercon cable to connect up to max.
16A (power).
10.
Fuse holder with glass fuse:
replace with the correct fuse, see technical information
11.
Hole to use the base as hanging bracket to fix the projector in truss, using a mounting hook.
12.
IR sensor
13.
[ID-Set] button : used to connect projector wireless to another projector. (see chapter : [HOW TO
SETUP])
14.
Test button : push this button to check the battery status (25 – 50 – 75 or 100% charged)
15.
[Wireless DMX] Indicator : shows the wireless status (see chapter : [HOW TO SETUP])
16.
Microphone : allows the projector to work in audio-mode.
17.
[Power ON/OFF] button : push this button to turn the projector ON or OFF
18.
Audio sensitivity button : turn this button left or right to adjust the microphone’s sensitivity to sound.
19.
[MENU] button : push this button to select the desired topic in the menu
20.
▲ button : push this button to go up in the menu
21.
Display
22.
▼ button : push this button to go down in the menu
23.
[ENTER] button : push this button to confirm the selected setting
24.
[Wireless ON/OFF] button : push this button to switch ON or OFF the wireless transmitter/receiver in the
projector.