![background image](http://html1.mh-extra.com/html/jayco/seneca/seneca_owners-manual_3687440077.webp)
SECTION 9
CAMPING & OPERATING
1. Pull the drape toward the front of the
motor home and behind the driver's side
sun visor. Open the sun visor against the
windshield to hold the drape in place.
2. Proceed across the windshield to the
passenger side, again placing the drape
behind the sun visor and opening the sun
visor to hold the drape in place.
3. Attach the black plastic hook at the
passenger's side of the cab to the loop
attached to the wall behind the
passenger's seat.
4. Attach the Velcro® at the top edge of the
drape above the driver's and passenger's
doors to the corresponding Velcro on the
roof of the motorhome cab.
5. The Velcro® at the bottom corners of the
privacy drape under the black plastic
hooks should also be attached to the
Velcro on the walls of the motorhome in
the corresponding locations.
T
ELEVISION
P
OWER
S
UPPLY
For good station reception, the
TV power supply must be turned
ON to view local television
stations. Turning the TV power
supply ON sends 12-volt DC
through the cable to the TV roof
antenna. The voltage energizes
the transistors in the antenna
head amplifier. The TV signal
then comes down the cable to
the outlets.
Turn the TV power supply OFF to view cable
television or to use a VCR or DVD.
T
ELEVISION
R
OOF
A
NTENNA
To view local stations at either (or both) the
front or bedroom television sets using the
television antenna, make sure the TV power
supply is ON and the TV roof antenna is
raised to the operating position.
The following is an overview of the antenna
operation. Refer to the manufacturer’s user
guide included in your Warranty
Packet for detailed operating instructions, or
visit the manufacturer’s
website.
Raising the antenna
To raise the TV antenna to the operating
position turn the antenna elevating crank
clockwise in the UP direction (approximately
13 turns) until some resistance to turning is
noted.
On amplified models, 12-volt DC power is
required. After the antenna is in the full UP
position, pull down on the round knob with
both hands until it disengages from the ceiling
plate. Rotate the knob for best picture.
To Test
1. Make sure the television set is working
properly.
Fig. 9.1 TV
Power Supply
2. Switch the power supply ON and OFF to
see if there is a difference in the picture
quality while watching TV. If there is no
difference, refer to manufacturer's manual
for further testing procedures.
The TV power supply should be turned
OFF when connecting/disconnecting the
cables to the power supply and antenna,
but should be turned ON when testing for
voltage.
9 - 3
Содержание SENECA
