Jayco SENECA, Руководство пользователя

Страница: 69 / 93

SECTION 7
PLUMBING SYSTEM
1. To make drainage easier, level the motor
home.
2. Remove the sewer hose housing dust
cap, and attach the sewer hose.
3. Place the end of the sewer hose into the
approved dump station.
4. Open the black tank dump valve (close it
when the black water holding tank is
emptied).
5. Open the grey tank dump valve (close it
when the grey holding tank is emptied).
6. Remove, clean and store the sewer hose.
7. Close the sewer hose housing dust cap.
You can locate many dump stations
throughout the United States and Canada in
Woodall’s, Rand McNally Camp Guide, Good
Sam Camp Guide, KOA Kampgrounds Camp
Guide and various other publications. Some
fuel stations also have dump stations.
Please contact your RV dealer for assistance
in the purchase and installation of a sewer
hose and/or sewer hose extension (if
needed).
B
LACK
T
ANK
F
LUSH
(
IF SO EQUIPPED
)
The black tank flush is also called a “no fuss
flush.” The fresh water from the non-toxic
drinking water hose goes directly into the
black water holding tank where there is a
“sprayer” connection located. This allows you
to clean the black water holding tank by
removing debris and preventing accumulation.
There is a check valve incorporated in the
plumbing lines to prevent back flow. Flush the
black water tank each time the grey and black
water holding tanks are dumped or as
needed:
1. Dump the black water tank and leave the
black tank drain valve open.
2. Connect a garden hose from the water
supply source to the “black tank flush.”
3. With the water source turned ON, flush
the black water holding tank until the
water running out of the black tank drain
valve is clear (not discolored or cloudy).
4. Disconnect the garden hose and close the
“black tank drain” valve. Fasten the sewer
hose housing dust cap back on the “black
tank flush.”
T
OILET
The toilet is efficient and easy to operate.
Generally, more water is required only when
flushing solids. Prior to using the sanitation
system, it is strongly recommended to flush
the toilet several times to release sufficient
water into the holding tank. If there is not a
sufficient amount of water used during
flushing, the waste materials may not
evacuate properly from the drain line to the
tank. Clogged tanks and pipes could
eventually occur.
The toilet system will perform better when
water is run for ten to fifteen seconds after
flushing to ensure that the waste will proceed
to the bottom of the tank.
It is important to prevent solid waste
buildup. Follow the toilet manufacturer’s
recommended instructions each time after
emptying the black water holding tank.
Do not use the same hose to fill your fresh
(potable) water tank that is used for the
black tank flush.
The black tank drain valve must be OPEN
any time there is a hose (water supply)
connected to the black tank flush.
Do not leave any hose (water supply)
connected to the black tank flush when it is
not in use.
7 - 13