![background image](http://html1.mh-extra.com/html/jayco/seneca/seneca_owners-manual_3687440023.webp)
SECTION 2
OCCUPANT SAFETY
If your alarm reactivates within a 24-hour
period, repeat steps 1-4 and call a qualified
appliance technician to investigate for
sources of carbon monoxide from fuel burning
equipment and appliances, and inspect for
proper operation of this equipment. Make
sure that motor vehicle(s) are not, and have
not been, operating in an attached garage or
adjacent to the motor home.
If problems are identified during this
inspection, have the alarm serviced
immediately. Note any combustion equipment
not inspected by the technician and consult
the manufacturer’s instructions or contact the
manufacturer directly for more information
about carbon monoxide safety and this alarm.
Alarm Signals
Normal Operation
: The LED will
maintain a steady green light, indicating
that the alarm is powered.
CO alarm condition
: The red LED light
will remain steady and the alarm will
sound 4 “BEEPS” then silent for 5
seconds. These signals indicate
immediate action is required.
Propane gas alarm:
The red LED light
will flash and the alarm will sound a
steady tone. These signals indicate
immediate action is required.
Alarm malfunction/low battery:
The
gas LED will remain off and the
Operational/CO LED will alternate
re/green and the alarm will sound once
every 15 seconds.
End of life alarm:
The LED will flash
red/red, green/green and the alarm will
“BEEP every 25-30 seconds. The alarm
should be immediately replaced.
Maintenance
Vacuum the alarm cover at least once a year.
Clean the cover by hand using a cloth
dampened in clean water. Dry with a soft
cloth. Do not spray the front panel of the
alarm with cleaning agents or waxes. This
action may damage the sensor causing an
alarm or cause the alarm to malfunction. Do
not paint the face of the alarm.
Testing the combination carbon monoxide/
propane alarm
The TEST/RESET button tests all
ELECTRICAL functions of the alarm. The
TEST/Mute switch is located on the front of
the alarm. Press and hold the test button for
1 second. The alarm is working properly if the
GREEN indicator light changes color to RED
and the horn beeps 4 times. The Gas LED
should also blink red.
NOTE
: Pressing the test button does not
check the sensor operation. Refer to the
carbon monoxide/propane alarm
manufacturers user’s manual provided in the
Warranty Packet for additional information on
testing the sensors.
The alarm will automatically sense when
the level of carbon monoxide in the air
reaches below dangerous levels. You
should stay outside the vehicle in fresh air
until the alarm is silenced. When the alarm
sounds, do not stand too close to the
alarm. The sound produced by the alarm
is loud because it is designed to wake a
person in an emergency. Prolonged
exposure to the alarm at a close distance
may be harmful to your hearing.
Test the alarm operation after the motor
home has been in storage, before each trip
and at lease once per week during use.
Never turn the 12-volt battery disconnect
control to the off position and disconnect
the battery cable to silence the alarm.
2 - 5
Содержание SENECA
